Layer lines and support marks come with almost every 3D print. Sanding is the simplest way to get rid of them, whether you print in PLA, PETG or resin. Here's a grit-by-grit process, plus which Durasand sanding tools make the job easier.
Before you start
- Wear a dust mask. Plastic and resin dust shouldn't be breathed in.
- Resin prints: wash and fully cure the print before sanding, and wear gloves. Sanding wet keeps resin dust out of the air.
- PLA softens with heat. Use light pressure and keep the abrasive moving so friction doesn't gum up or melt the surface. Sanding wet also helps keep it cool.
Quick grit chart for 3D prints
| Job | Grit | Durasand pick |
|---|---|---|
| Removing support nubs and blobs | 100 to 180 | Black 100/180 Sanding Stick or Twig |
| Leveling layer lines | 120 to 240 | Blue 120/240 Sanding Stick for flat faces |
| Smoothing filler primer | 240 to 320 | Yellow 240/240 or Pink 280/320 Sanding Stick |
| Holes, slots and fine detail | Match the job | Sanding Twigs |
| Curved and organic shapes | Match the job | Sanding Squares or High Flex Pads |
Step by step
1. Remove supports
Snap or cut supports away, then trim what's left close to the surface with flush cutters or a hobby knife. Sand the remaining nubs flush with 100 to 180 grit. A Sanding Stick keeps flat faces flat while you work.
2. Level the layer lines
Start with the coarsest grit you need: about 120 for heavy layer lines, 180 for fine ones. Sand until the ridges are gone, changing direction now and then so you don't dig grooves. Then step up to 240 to remove the sanding marks.
3. Fill and prime
Filler primer fills the last fine lines and pinholes. Let it dry fully, then sand it back with 240 to 320. Repeat until the surface looks smooth under a light coat of primer.
4. Final pass before paint
Finish with 320 grit, clean off the dust, and your print is ready for color.
Sanding wet
Sanding Twigs are washable and work wet or dry, and High Flex Pads also work wet or dry. Dip the abrasive in water and rinse it often to keep it cutting. Let the print dry completely before priming.
Which Durasand tool to use
- Flat faces and crisp edges: Sanding Sticks. The firm core keeps surfaces flat.
- Holes, slots, gaps and fine detail: Sanding Twigs. Thin and flexible, they reach where other sanders can't.
- Curves and organic shapes: Sanding Squares and High Flex Pads, which have soft foam backs that follow the shape.
- Miniatures and small prints: Mini Sanding Sticks.
Not sure which grits you'll use most? The Sanding Sticks Grit Sampler and Sanding Twigs Grit Sampler include every grit from 80 to 320. The Grit Guide has the full color chart.